RF CO2 Laser Tube

Description

Features: Superior beam quality, power stability and rugged reliability Industry
leading compact size with integrated RF power supply Air and liquid cooled
configurations available high quality laser processing on a wide range of
materials CR Lasers parametersCR30C / CR40C CR30C Model CR30C Wavelength 10.6 µm Power >30W Power stabilit <±5% Mode m2 <1. 2 Beam diameter 2±0.2mm Divergence angle <7mrad Polarization >100: 1,
Horizontal linear polarization Modulation frequency 0-25kHz, 0-100%
Electrical input 48VDC, 12. 5A Cooling method Air cooled/Water cooling 4L/M
Heat dissipation 500W Size Air cooled 360 X 93 X 145, Water cooling 360 X
93 X 95 Life 20000 hours (Inflatable) Warranty time 2 years CR40C Model CR40C Wavelength 10.6 µm Power >45W Power stabilit <±5% Mode m2 <1. 2 Beam diameter 2±0.2mm Divergence angle <7mrad Polarization >100: 1,
Horizontal linear polarization Modulation frequency 0-25kHz, 0-100%
Electrical input 48VDC/10A Cooling method Air cooled/Water cooling 4L/M
Heat dissipation 500W Size 357X93 X 145 Air cooled/ 357 X 93 X 95 Water
cooling Life 20000 hours (Inflatable) Warranty time 2 years Pulse width modulation (PWM):Laser is controlled laser power by Pulse width modulation (PWM). The low
voltage range should be 0 to 0.5V (laser off), the high voltage, ranges
should be 3.5V to 5V (laser on). Pulse width modulation or PWM, controls
laser power by varying the duty cycle which is supplied by the external
controller. The modulation frequency is 0-20KHZ. The duty cycle is 0-100%.Specific steps are as follows: 48VDC power access to laser power input terminal block. connect ,
-connect-. The external controller signals access to laser BNC connector
through Coaxial cable. The inner core of BNC connector connects with of PWM
signal. The shell of BNC connector connects with ground of PWM signal. Open
the DC power, at this time the green indicator should illuminate (shown
that Laser has been normally powered). PWM signal is set to a certain duty
cycle by Controlling card software on the computer, at this time the red
indicator should illuminate (shown that it has laser output).